Moto Mote - The Stealth Garage Door Remote

Convenience. Simplicity. Stealth.

Say goodbye to fumbling for remotes in your pocket or pulling out your phone every time you roll up to your garage. The Moto Mote 3D-printed Micro Button Garage Door Remote gives you discreet, seamless access to your garage door — hidden on your motorcycle with no extra hard-wiring necessary.

Designed for discreet installation and effortless use, this compact system features a low-profile micro button that can be hidden anywhere: handlebars, brake reservoir, under a dash, along a fairing, or even tucked into a tank or handlebar bag.

Key Features

• Compact & Stealthy Design: Easily hidden for a clean, safe, factory look. The transmitter is approximately 2 1/8" x 1 3/8" x 3/8" (55x35x10mm)
• Easy Mounting Options: Install with VHB tape, Velcro tabs, or a Velcro strap — your choice.
• Quick Access: Pick your model. One press opens your Genie or Liftmaster/Chamberlain/Craftsman door (must have purple, red, orange, yellow, or green learn button, does not work with the newest Security+ 3.0 models.)
• Custom 3D-Printed Housing: Durable, weather-resistant, and purpose-built for bikes.
• No Wiring Hassle: Battery-powered and self-contained — just pair, mount the button and transmitter, and go.

Mounting Options Included

• VHB tape for the button and the transmitter
• Double-stick Velcro to attach anywhere or for easy removal
• Velcro strap for the transmitter to wrap around a bar, wires, tubing, or cables

Important Notes

• Make sure you select the right variant. Moto Motes are compatible with Genie, Chamberlain, Liftmaster, and Craftsman opener, but use different boards depending on the manufacturer.
• Choose placement carefully — the further you tuck it in, the less effective the range. Not recommended under a motorcycle gas tank.
• Button cable length is approximately 10" to prevent burying the transmitter too deep.
• Printed in PA6-GF. Layer lines are visible and there may be very minor imperfections.
• Screws go into heat-set brass fittings and are extremely durable.
• PA6-GF is very heat resistant, but please don't place it directly on your engine or extremely close to your exhaust.
• Uses stock, brand-name transmitters modified for use with the mini switch in a custom housing.
• Powered by a CR2032 battery, easily swapped by removing two screws. Expect a couple of years per battery.
• Programming: press and hold the "learn" or "program" button on your opener, then press the remote button twice. Super easy.